Events and Updates#
Cloud-init will fetch and apply cloud and user data configuration upon several event types. The two most common events for cloud-init are when an instance first boots and any subsequent boot thereafter (reboot). In addition to boot events, cloud-init users and vendors are interested in when devices are added. cloud-init currently supports the following event types:
BOOT_NEW_INSTANCE: New instance first boot
BOOT: Any system boot other than ‘BOOT_NEW_INSTANCE’
BOOT_LEGACY: Similar to ‘BOOT’, but applies networking config twice each boot: once during Local stage, then again in Network stage. As this behavior was previously the default behavior, this option exists to prevent regressing such behavior.
HOTPLUG: Dynamic add of a system device
Future work will likely include infrastructure and support for the following events:
METADATA_CHANGE: An instance’s metadata has change
USER_REQUEST: Directed request to update
Datasource Event Support#
All Datasources by default support the
Each Datasource will declare a set of these events that it is capable of
handling. Datasources may not support all event types. In some cases a system
may be configured to allow a particular event but may be running on
a platform whose datasource cannot support the event.
Configuring Event Updates#
Update configuration may be specified via user data, which can be used to enable or disable handling of specific events. This configuration will be honored as long as the events are supported by the datasource. However, configuration will always be applied at first boot, regardless of the user data specified.
Update policy configuration defines which events are allowed to be handled. This is separate from whether a particular platform or datasource has the capability for such events.
scope: <name of the scope for event policy>
scope value is a string which defines under which domain does the
event occur. Currently the only one known scope is
network, though more
scopes may be added in the future. Scopes are defined by convention but
arbitrary values can be used.
when: <list of events to handle for a particular scope>
scope requires a
when element to specify which events
are to allowed to be handled.
When the hotplug event is supported by the data source and configured in user data, cloud-init will respond to the addition or removal of network interfaces to the system. In addition to fetching and updating the system metadata, cloud-init will also bring up/down the newly added interface.
Due to its use of systemd sockets, hotplug functionality is currently incompatible with SELinux. This issue is being tracked on Launchpad. Additionally, hotplug support is considered experimental for non-Debian based systems.
apply network config every boot#
On every boot, apply network configuration found in the datasource.
# apply network config on every boot updates: network: when: ['boot']